Serving Los Angeles & Orange County · Commercial · Storefront · Institutional · Residential
Licensed CA Contractor #997737 · (310) 488-5626 · 888-960-TINT
CERAMIC SOLAR FILM — infrared heat stopped at the glass, your view left alone · Free written quote →

Home / Blog / Indoor Heat Rule and Sun-Facing Glass

California’s Indoor Heat Rule (Cal/OSHA § 3396) and Sun-Facing Glass: What the Rule Requires, Where Window Film Fits, and What It Doesn’t Do

If you run a warehouse, shop, restaurant or office in Los Angeles or Orange County and have a hot room behind west- or south-facing glass, you may wonder whether California’s indoor heat rule says anything about window film. We read the regulation, Cal/OSHA’s own guidance pages and the Standards Board’s rulemaking record. The short version: the rule is a heat illness prevention program, and none of those documents names glass or film. This is general information, not legal advice.

Published November 22, 2026 · Armored Glass Solutions

The Short Answer

The rule requires a program, not a product

Title 8 section 3396, “Heat Illness Prevention in Indoor Places of Employment”, went into effect on July 23, 2024, according to Cal/OSHA. We read the full text of the section on November 21, 2026 and searched it for glass, film, tint and solar. None of those words appears. The one mention of a window is in the definition of an indoor space, which lists windows among the barriers that enclose it.

So the choice of control measures belongs to the employer, work area by work area. Window film can be one measure that reduces solar heat gain through glass. It is not a substitute for the rule’s written plan, water, cool-down area, training, emergency response or your air conditioning.

Our own work is film (including solar-control film), overglaze polycarbonate and door reglaze. Air conditioning, shade structures, cool-down rooms, written plans and training belong to other trades and advisers.

What The Rule Requires

What the rule requires, and the 82 versus 87 degree confusion

The section “applies to all indoor work areas where the temperature equals or exceeds 82 degrees Fahrenheit when employees are present”. Cal/OSHA summarizes it the same way: “This standard applies to most workplaces where the indoor temperature reaches 82°F.” From 82 degrees, the baseline duties apply: water, a cool-down area, emergency response procedures, acclimatization, training and a written plan.

Subsection (e) is where people stumble. It covers measuring the temperature and heat index, evaluating other risk factors and using control measures, and it applies only under listed conditions: “The temperature equals or exceeds 87 degrees Fahrenheit when employees are present”; “The heat index equals or exceeds 87 degrees Fahrenheit when employees are present”; or 82 degrees where employees wear clothing that restricts heat removal or work in a high radiant heat area. We would not read the rule as requiring engineering controls at 82 degrees for employees in ordinary clothing.

Where subsection (e) applies, the measurement records must include the date, time and specific location, and are kept for 12 months or until the next measurements are taken, whichever is later. The written plan is its own duty: “The employer shall establish, implement, and maintain an effective Heat Illness Prevention Plan.” It must be in writing in English and in the language understood by the majority of the employees.

We did not find a small-business, retail or restaurant carve-out. The exemptions we read cover teleworking from a place the employer does not control, incidental exposures under 15 minutes in any 60-minute period, emergency operations, and certain state prisons, local detention facilities and juvenile facilities. The rule traces to Labor Code section 6720, which told Cal/OSHA to propose “a standard that minimizes heat-related illness and injury among workers working in indoor places of employment” by January 1, 2019. The Standards Board approved the standard on June 20, 2024.

We re-checked the section’s history line on November 22, 2026, and it still showed only the July 23, 2024 filing. We did not search for pending bills.

Where The Sun Shows Up

Where sunlight appears in the text

The sun is named in three places. The definition of environmental risk factors includes “radiant heat from the sun and other sources”. The definition of radiant heat says “Sources of radiant heat include the sun, hot objects, hot liquids, hot surfaces, and fire.” And the cool-down area, a place to rest and recover, must be “blocked from direct sunlight”. A west-facing break room is the plain-English version of that last one, though the rule leaves the method to the employer.

The Standards Board’s Initial Statement of Reasons makes the link between warehouses and weather in one sentence: the temperature inside a warehouse can be “significantly affected by the temperature and amount of sunlight outside the establishment”. That sentence does not discuss glass.

Measurement is where the sun gets complicated. The rule defines temperature as the dry bulb reading, taken “without considering humidity or radiant heat”, and the heat index leaves radiant heat out too. A separate test, the globe temperature, defines a high radiant heat area as one at least five degrees Fahrenheit above the temperature. Cal/OSHA’s FAQ says a thermometer should be “freely exposed to the air but shielded from radiant heat sources, such as the sun”. We found no guidance on how a sunlit window area would be classified, and we will not guess. It depends on the measurement.

Engineering Controls

What counts as an engineering control

The rule defines an engineering control as “a method of control or a device that removes or reduces hazardous conditions or creates a barrier between the employee and the hazard”. Its examples are said to “include, but are not limited to” air conditioning, cooling fans, evaporative coolers, local exhaust ventilation, natural ventilation when outdoor air is cooler, and “shielding from a radiant heat source”. Shielding is defined as “a physical barrier between radiant heat sources and employees that reduces the transmission of radiant heat”. Cal/OSHA’s FAQ lists “Reflective shields to block or reduce radiant heat.” It also lists open windows, for ventilation when it is cooler outside than inside.

Where subsection (e) applies, engineering controls come first. They are to reduce the temperature and heat index below 87 degrees “except to the extent that the employer demonstrates such controls are infeasible”. The regulation does not define feasible. Cal/OSHA’s FAQ calls it “a fact-sensitive question” and says infeasibility would be “evaluated on a case-by-case basis”. We are not characterizing what is feasible for any employer.

Where Film Fits

Where window film fits, and what the rule does not say

As the National Fenestration Rating Council puts it, in the words we quoted in our post on when film is enough and when new windows are needed: “Solar control window film reduces solar heat gain by reflection and absorption.” That is why film is a reasonable thing to ask about for a room whose heat comes through sun-facing glass. Our cooling bills post covers the research on glass and cooling load, and the ceramic versus cheaper film post covers how film types differ.

What the rule does not say matters as much. We searched the regulation, Cal/OSHA’s indoor heat FAQ, its employer fact sheet, its model program, the Initial Statement of Reasons and the Board’s updated final statement of reasons for film, solar and tint. Each came back with no hits. We found no official source that says film counts as shielding, and none that says it does not. So we are not saying film qualifies, and we are not saying it fails to. Cal/OSHA Consultation or your own counsel is the place to ask.

The model program Cal/OSHA publishes carries its own caution: “Use of this program does not guarantee compliance with sections 3395 or 3396 and does not shield an employer from being cited for violations of those sections.” No single product changes that.

If film is on the table for commercial dual-pane glass, we check thermal-stress compatibility before recommending it; see our dual-pane post. Our solar film page describes the service.

Reading A Spec Sheet

Reading a spec sheet honestly

Film spec sheets publish percentages, and the test glass matters. Solar Gard’s Clear Frost data sheet, a light frosted film, lists total solar energy rejected of 34 percent on a single pane and says “Performance results were generated from testing 4mm thick clear glass.” Avery Dennison’s design guide lists 78 percent on a single pane for one dark interior reflective film, with visible light transmitted of 18 percent, and says its results are “calculated on 3 mm glass using NFRC methodology”. We name them only as published examples, not as recommendations.

The two examples show the trade-off. The higher number comes with a much darker film, so view and daylight are part of the decision. Both sheets say their results are “only intended for estimating purposes”.

None of this is a room temperature. The sheets give percentages of solar energy on a stated glass, calculated by software. The rule’s thresholds are measured as air temperature or heat index in the work area. We found no source that connects one to the other, so we do not publish a degree figure. Cal/OSHA lists “Radiant heat from the sun and other sources, like machinery, stoves, ovens, etc.” among the risk factors, and film addresses only glass. Our spec sheet guide explains VLT, SHGC and TSER in detail.

What Film Does Not Do

What film does not do

Film does not provide drinking water, a cool-down area, rest, training, emergency response procedures or acclimatization, all of which the rule lists. It does not write your plan. It does not cool a room that is hot because of machinery, stoves or ovens, and it does not replace air conditioning. Treat it as, at most, one measure that reduces solar heat gain at the glass, inside a program the employer builds.

A Site Walk

A site walk that helps your plan

  • Which rooms have west- or south-facing glass? Note the orientation and the room use.
  • Where are the hot spots? Where do people stand, sit and work during the sunniest hours?
  • Where is the cool-down area? The rule asks that it be “blocked from direct sunlight”. Check whether direct sun reaches it.
  • What are you recording? Where subsection (e) applies, records carry the date, time and specific location of each measurement.
  • Is the glass dual-pane? Tell us before we talk about film; we check compatibility first.
  • Who confirms the rule’s application? Ask Cal/OSHA Consultation or your own counsel.

Prefer to talk it through? Call us at (310) 488-5626 or 888-960-TINT. We will tell you what we do and what belongs to another trade.

Questions

The indoor heat rule and sun-facing glass: FAQ.

Does California's indoor heat rule require window film or tint on sun-facing glass?

Not in the rule's text. We searched the full text of Title 8 section 3396 and it has no mention of glass, film, tint or solar control. It requires a written Heat Illness Prevention Plan, water, a cool-down area, emergency response procedures, acclimatization and training, and where subsection (e) applies it requires measurement, records and control measures. It leaves the choice of control measures to the employer, so film is one possible measure at most. Whether it fits your building depends on your own assessment, and we are not giving legal advice.

At what temperature does the indoor heat rule apply: 82 or 87 degrees?

Both numbers matter. The section "applies to all indoor work areas where the temperature equals or exceeds 82 degrees Fahrenheit when employees are present", and the baseline duties follow from that. Subsection (e), which covers measuring, evaluating risk factors and using control measures, applies where the temperature or the heat index reaches 87 degrees, or at 82 degrees where employees wear clothing that restricts heat removal or work in a high radiant heat area. Check which one describes each of your work areas with Cal/OSHA Consultation or your own counsel.

Does window film count as an engineering control under section 3396?

We could not find an official source that says so, and we could not find one that says it does not. The regulation's list of engineering controls includes "shielding from a radiant heat source", and it says the examples "include, but are not limited to" the ones listed. It does not name film, glass or tint, and neither do Cal/OSHA's FAQ, fact sheet or model program. So we do not say film qualifies. If the question matters to your plan, ask Cal/OSHA Consultation or your counsel.

How much cooler will my warehouse or office be with film?

We cannot give you a number, and a spec sheet cannot either. Manufacturer figures are percentages of solar energy on a stated test glass, calculated by software, and one maker's sheet calls them "only intended for estimating purposes". They are not a measured room temperature, and the rule's thresholds are measured as air temperature or heat index in the work area. Other things also affect a room's temperature, including equipment, ventilation and your air conditioning, which film does not address.

Does the indoor heat rule apply to small retail shops and restaurants?

We did not find a carve-out for small businesses, retail or restaurants in the text of section 3396. The exemptions we read are for teleworking from a location the employer does not control, incidental heat exposures of less than 15 minutes in any 60-minute period, emergency operations, and certain state prisons, local detention facilities and juvenile facilities. Whether the rule applies to a particular shop depends on its work areas and temperatures, so check with Cal/OSHA Consultation or your own counsel.

Sources

Where these findings came from.

We read the regulation and agency pages below on November 21, 2026 and re-checked the regulation’s history line on November 22, 2026. Agency guidance and rulemaking commentary are not law and change over time. We did not read the penalty provisions, did not look for Cal/OSHA enforcement interpretations of sun through windows, and did not read the heat index chart in the regulation’s appendix.

  1. 8 CCR section 3396, Heat Illness Prevention in Indoor Places of Employment. State regulation text on the DIR site. Link.
  2. Cal/OSHA, Heat Illness Prevention hub page. State agency. Link.
  3. Cal/OSHA, Indoor Heat FAQ. State agency guidance, not law. Link.
  4. Cal/OSHA, Indoor Heat employer fact sheet. State agency overview, not all of the requirements. Link.
  5. Cal/OSHA, Model Heat Illness Prevention Plan (sample procedures). Optional template; we link to it and do not host it. Link.
  6. Occupational Safety and Health Standards Board, Indoor Heat rulemaking index. Link.
  7. Standards Board, Initial Statement of Reasons, indoor heat. Link.
  8. Standards Board, Updated Final Statement of Reasons, indoor heat. Link.
  9. California Legislative Information, Labor Code section 6720. State statute. Link.
  10. Solar Gard (Saint-Gobain), Clear Frost data sheet. Manufacturer data; calculated, for estimating only. Link.
  11. Avery Dennison, Architectural Window Film Design Guide (January 2023). Manufacturer data; calculated, for estimating only. Link.

Keep Reading

California’s Workplace Violence Law (SB 553) and Your Storefront Glass: What the Plan Requires, What It Doesn’t, and Where Glass Fits

Another Cal/OSHA rule that requires a plan and names no glass or film.

Read the post →

Does Window Film Lower Cooling Bills in Southern California? What the Research Shows — and Where Title 24 Fits

What independent studies measured about glass, film and cooling load.

Read the post →

Reading a Window Film Spec Sheet: VLT, SHGC, TSER and What They Don’t Tell You

What each published film number measures, and what it leaves out.

Read the post →

Hot room behind sun-facing glass?

Start with your own assessment and your written plan. If glass is part of the picture, call us and we will talk through what film or overglaze polycarbonate can and cannot do, and what belongs to another trade. Call (310) 488-5626 or 888-960-TINT.

Contact Us
CALL TEXT QUOTE